DOWNLOAD ASTM C633-01

If no such substrate material is speci? Don't have an account? You already recently rated this item. Active view current version of standard. These are two-part mixes that should be cured at room temperature when used for this test method.

Uploader:	Nashura
Date Added:	26 June 2012
File Size:	63.4 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	35483
Price:	Free* [*Free Regsitration Required]

A number in parentheses indicates the year of last reapproval.

When the adhesive is new, typical adherence strength to thermal spray coatings may range up to approximately psi 55 MPa depending on the coating material. Because of residual stresses in thermal spray coatings, actual strength depends upon the shape of the particular coated part.

A recommended method is to use a surface grinder with a magnetic chuck, positioning the rear face of the coated? The loads used in determining the adhesion or tensile strength shall be within the loading range of the testing machine, as de? Higher temperature testing is restricted by the need for a suitable adhesive bonding agent.

Unless proved satisfactory by comparison testing, any agent requiring elevated temperature for curing should be avoided because viscosity may decrease at high temperature, allowing penetration.

Please re-enter recipient e-mail address es. Please enter the message. Please enter your name.

Metallographic Lab

Please choose whether or not you want other users to be able to aastm on your profile that this library is a favorite of yours. Standard Test Method f Add a review and share your thoughts with other readers.

Precision and Bias If any other bonding agent is to be used, it shall? The facing shall be mechanically cleaned by such means as machining, grinding, light grit blasting, or rubbing with emory cloth. Excessive adhesive shall xstm wiped from the assembly with soft paper or cloth. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?

Some features of WorldCat will not be available. Both ends of each?

NOTE 2—Thermal spray coatings may have an inherent porosity. A layer greater than 0.

For certain fundamental investigations, it is suggested that very low cryogenic temperature be used. Your rating has been recorded.

ASTM C Standard Test Method for Adhesion or Cohesion Strength of Thermal Spray Coatings_百度文库

Your list has reached the maximum number of items. It is not recommended for thermal spray oxide or other porous ceramic coatings because of the possibility of excessive penetration into the coating. However, formatting rules can vary widely between applications and fields of interest or study.

Alternatively, new adhesive bonding agents that would allow reduction of the minimum thickness limitation may become available. Self-alignment is often provided by the manufacturer as an integral part of the testing machine. Citations c633--01 based on reference standards. Further development may establish that thin layers of certain types of especially dense coatings may be tested satisfactorily. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

Only a rough grinding or machining step is needed, to provide a? Alternatively, new adhesive bonding agents that would allow reduction of the minimum thickness limitation may become available. Care must be taken to avoid contaminating the prepared surface before coating. Such a layer of substrate material need not be metal. Find a copy in the library Finding libraries that hold this item